This heat sink was nice and thick, and instead of hoarding it i thought it looked like an FPR bracket.
A cut or two, and some drilling later and this is made up. The regulator is insane overkill honestly and is probably for a 4 digit blow through car. Think I paid $30 on Craigslist for it so W/E. I need different hardware but good enough for now. It may be a bit high, but I don't think so. I need fuel lines next as well from the fender to the fpr. To get it functional, an oil pressure switch, pump wiring and a few other bits still need done.
Up next is the fuel lines. the thing I need to figure out is how long they neeed to be, and how much slack I need in them. I think I'll be a hair short with the line I have even if I roll up new ones. Have to get that squared too.