First off, please don't post any comments on getting rid of the IRS and putting in a sold.
went to the byron dragway today and sat most of the day. I only got in 3 runs and didn't fair so well in the 60ft department. I just put in a new diff and I've never actually had the ability to launch the car properly since I've owned it (bought the car with a bad diff apparently). Anyways I'm asking what you guys are launching at so next time I will have better luck.
I have an auburn hd diff with the stock 3.55 in the rear. I replaced all the irs subframe bushings with the MM uerathane bushings as well as the pumpking mounting bushings. I also have a billetflow irs brace on.. I am running the stock halfshafts.
I'm was running 20psi of air in my DR's and they are 275 45 17 Micky Street radials
the best i got was a 1.97 60ftr with a 4k launch which I still bogged out of the hole. If I had more time and could of gotten in more runs I'm sure I would of improved on that, but the same time I seen a fellow brother break a halfshaft prior to that run which discouraged me from getting crazy out there.
Any advice for next time would be appreciated.
went to the byron dragway today and sat most of the day. I only got in 3 runs and didn't fair so well in the 60ft department. I just put in a new diff and I've never actually had the ability to launch the car properly since I've owned it (bought the car with a bad diff apparently). Anyways I'm asking what you guys are launching at so next time I will have better luck.
I have an auburn hd diff with the stock 3.55 in the rear. I replaced all the irs subframe bushings with the MM uerathane bushings as well as the pumpking mounting bushings. I also have a billetflow irs brace on.. I am running the stock halfshafts.
I'm was running 20psi of air in my DR's and they are 275 45 17 Micky Street radials
the best i got was a 1.97 60ftr with a 4k launch which I still bogged out of the hole. If I had more time and could of gotten in more runs I'm sure I would of improved on that, but the same time I seen a fellow brother break a halfshaft prior to that run which discouraged me from getting crazy out there.
Any advice for next time would be appreciated.