🔧 Technical Injectors failing flow test after cleaning

[v6buicks]

I've never been in this situation. The injectors are only two years old with about 5k miles on them. Granted, they inject E85 and sit a lot. I just want to get some opinions on whether it's okay to replace a single injector or if I should just buy a whole set. My issue is that I don't really know what I'm looking at. The injectors are genuine Siemens 80 pounders, but is the high flower bad or all the others bad?

Click to read more...

 

[DEEZUZ]

Uuuhhhmmm you gotta have flow specs

 

[Turbocharged400sbc]

Find the percentage variance mark it and then change your injector skew table

 

[v6buicks]

Uuuhhhmmm you gotta have flow specs

Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 80 lb/hr = 630 cc/min = 850 cc/min.
Dynamic Flow Rate: 18.6 mg/pulse 2.5ms PW, 20 ms Period.

 

[v6buicks]

Forget it. I'm a chump. I'll get a new set.

 

[DEEZUZ]

Is that an actual test bench or did you make it?

 

[v6buicks]

I sent them to a buddy who has an ultrasonic cleaner and a flow bench at his school. I don't know anything past that to be honest.