Can anyone tell me what P0113 & P0148 mean. The check engine light came on as pulled in the driveway, lucky me. These are the code I found.
I don't want to have go to Autozone for info.
I don't want to have go to Autozone for info.
follow_along_with_video_below_to_see_how_to_install_our_site_as_web_app
Note: this_feature_currently_requires_accessing_site_using_safari
Since 1964 said:Can anyone tell me what P0113 & P0148 mean. The check engine light came on as pulled in the driveway, lucky me. These are the code I found.
I don't want to have go to Autozone for info.
Sorry to hear about the headersSince 1964 said:NO new mods for last 3 years other than JBA shorties...(.OK TO Laugh now).
I would stay with the Ford filter. It works. I would change it. 2 years is a long time.Since 1964 said:There has been a code which I didn't see that was removed before a leak was fixed on my pass., side exhaust where the mid pipe connects to the header.
I had gone in for the leak and just as I got there the check enging light came on so I really never saw it or read up on what it was but most likely interference with the 02 sensors due the leak is what Sutton said it was.
I was just at autozone and grabbed a new IAT sensor for 14 bucks even though mine looks fine, but if the code pops again I can change it.
As far as fuel????? I think I got a new filter with the instalation of the dual focus pumps but that's few years now so I'll get that changed.
Any suggestions for a fuel filter or just stay with Ford? I probably won't see anything after that I bet. I also got some electronics cleaner and I'll clean my SCT 2400. Can't hurt right?
FWIW it just drove fine to and from the Autozone and no code popped again. I'm going to clean the mass air and wash the car and ride the hell out of it after that and see.
Thanks for the advice guys, I just love this site. It's nice to have the wizzards keeping an eye on us.
Dana said:Sorry to hear about the headers
I would stay with the Ford filter. It works. I would change it. 2 years is a long time.
O2 sensors fail on these cars too, so don't rule that out.
Use care when cleaning the MAF. Don't touch it with anything other than the spray.
Dan
Since 1964 said:I knew about the spray and my idle and general well being is much improved since the cleaning. Wires look good at the IAT connection and I bet it's just needing a fuel filter. My 02's are a little twisted so I may get a few new ones just for pre-emptive effects.
Thanks for the help guys.