AjL227's XP, S2 IC, 2.8" CompG build

[10sec]

Oh snap

 

[PANDA]

everyone building 3800's that could be fast and shit

 

[AjL227]

10sec, you should help me tune my setup when it's done. I'm a beginner, just got HPTuners Pro.

 

[10sec]

I might be able to help you out with that

 

[The Broken Regal]

 

[Turbocharged400sbc]

holy fuck where'd ya get your bluebird hoist?!?

i gots the same one

 

[AjL227]

holy fuck where'd ya get your bluebird hoist?!?

i gots the same one

Me and GTP Mike rented one from Buttrey today.

 

[Turbocharged400sbc]

ah mines a former low use rental... got it for 100$

tell mike if he fux up ill fux him up

 

[AjL227]

Come help us. There is beer and food in it for you.

 

[10sec]

mike knows what he's doing, i wouldn't be worried about it. James will just come over and throw stuff at you

 

[Turbocharged400sbc]

he should remember everything, esp how to setup the dbl roller properly

 

[AjL227]

he should remember everything, esp how to setup the dbl roller properly

This is exactly what I'm worried about the most. I do not want my dbl chain to snap.

 

[Turbocharged400sbc]

as long as its not a JP with the rolon chain you should be good to go even if you dont fit it properly to the US motor...like 10secondsofhacking does

 

[syP]

was the motor even pulled yet??


I shake my head if it wasnt yet

 

[10sec]

If only everyone was as good as the Syp

 

[syP]

If only everyone was as good as the Syp

 

[PANDA]

Good luck, I hope you don't have remote start.

 

[AjL227]

Progress... slow and steady...

I've got a lot of cleaning to do...

 

[10sec]

yes you do, that's worse than my cars!

 

[Turbocharged400sbc]

ditch the dex

 

[AjL227]

ditch the dex

I am switching to Prestone green 50/50. Mike said that you set up his dbl roller. I may need help with that, if you're willing...

 

[AjL227]

Did not work on the car most of the day, Wednesday. Started removing the whole top end around 10pm, yesterday. 1 and a half hours later, I had it all basically torn down, with everything in neat order. No chipped pistons, everything looked fairly clean for 58k. Now I need to remove the crankshaft pulley & harmonic balancer, and I do not have a puller. Anyone awake at this time, that has one?

 

[Turbocharged400sbc]

i replied that i had mine above my workbench at like 2:19 like 8 minutes after ya... i was still out in the garage

 

[AlmightyBirdman]

If you and Mike need help this weekend, tell him to give me a call. He has my number. I haven't seen that negro in months anyways. Last time I saw him was down at SIU in Carbondale.

 

[AjL227]

I need the crank gear machined to fit on the crank keyway, ASAP. Can anyone help me?? I'll make it worth your while.