I am selling my Weld RTS set up as it will not fit my new car.
The fronts wheels are 17x4.5 high pad fronts with 1.9 back spacing. Because of the high pad height they clear the 14" Brembo 4 piston calipers and rotors. They have M&H bias ply 28x4.5 front runners mounted on them.
The rear wheels are 15x10 with a 7.5 back spacing. They have M/T 28x10 stiff wall slicks mounted on them.
There is about 20 passes total on this set up. They were never used on the street. I would change both front and rear wheels/tires at the track.
I also have chrome McGard shank style lug nuts and stainless steel washers for the rear wheels. The fronts use a stock style conical lug nut. The set up was also balanced with "Road force" style balancing. They are located in Glen Ellyn.
Additional specs on the parts in the links below.
http://www.summitracing.com/parts/wld-71hb7047a19a
http://www.summitracing.com/parts/wld-71mb-510a75a
http://www.summitracing.com/parts/mnh-mss024
http://www.summitracing.com/parts/mtt-3055s
The set up new cost over $2500. $1800 obo
Front high pad wheel when new (so you can see they style of wheel).
The fronts wheels are 17x4.5 high pad fronts with 1.9 back spacing. Because of the high pad height they clear the 14" Brembo 4 piston calipers and rotors. They have M&H bias ply 28x4.5 front runners mounted on them.
The rear wheels are 15x10 with a 7.5 back spacing. They have M/T 28x10 stiff wall slicks mounted on them.
There is about 20 passes total on this set up. They were never used on the street. I would change both front and rear wheels/tires at the track.
I also have chrome McGard shank style lug nuts and stainless steel washers for the rear wheels. The fronts use a stock style conical lug nut. The set up was also balanced with "Road force" style balancing. They are located in Glen Ellyn.
Additional specs on the parts in the links below.
http://www.summitracing.com/parts/wld-71hb7047a19a
http://www.summitracing.com/parts/wld-71mb-510a75a
http://www.summitracing.com/parts/mnh-mss024
http://www.summitracing.com/parts/mtt-3055s
The set up new cost over $2500. $1800 obo
Front high pad wheel when new (so you can see they style of wheel).
Last edited:
, But my comfort zone is more in the $800-1000 range for a used dedicated track setup (aka these are 'more than you can afford pal'). They are goddamned sharp though. 
