Recent content by reaper mech

  1. reaper mech

    Build Woes...Any advice?

    stock ls pushrod is 7.400 but if you measure it with a set of digital calipers it will show 7.385 since you are measuring from the flats is the smoke white or a gray blue tint ? whiteish is normally coolant , gray blue burning oil .
  2. reaper mech

    Movie Mortal Kombat

    its a decent b movie reboot , could have left the entire cole family thing out of it and might have been a better movie
  3. reaper mech

    🔧 BUILD the odd turbo 2nd gen camaro

    ok time for an update to this , this is the first free time i have had since i started this post , steering rack in finally installed waiting on some hex stock so i can make my tie rod ends , welds arent the best of my ability , but i goofed on the angle and just decided to back fill the gap...
  4. reaper mech

    🔧 BUILD Fairmont Wagon LS Turbo

    what did ptc spec your converter at ? have a 2nd gen camaro that will end up around the weight your wagon is with a similar motor combo looking for an idea where to start
  5. reaper mech

    🔧 BUILD Big turbo LS Summit Racing Fbody build

    mexico streets getting it done again !! , car have an anti roll bar on it yet ?
  6. reaper mech

    🔧 BUILD 04 CTS-V L83/4L80e swap

    i see caddy pulled a ford trick with the abs lines lol , @denmah would get a kick out of that . curious on your thoughts on how you are going to do your hot side
  7. reaper mech

    Ford 8.8 swap F Body

    8.8 is fords version of the gm 12 bolt car rear from the late 60s to early 70's . fun fact 8.8,12 bolt car and 8.5and 8.6 (late model 10 bolt) all carry the same pinion bearings , and carrier bearings are shared except for the 8.5 it has a bit smaller bearing . the 9" is top tier in strength due...
  8. reaper mech

    🔧 BUILD 04 CTS-V L83/4L80e swap

    have any pics of the motor mounts ? have an idea
  9. reaper mech

    Kia ads?

    yep, i started laughing so hard after seeing it pop up
  10. reaper mech

    🔧 BUILD Z28 - 1999 Camaro Z28 - 5.3/S475/80E

    for the steam vents i tend to split the upper hose and use one of these : https://www.ictbillet.com/1-1-4-hose-w-1-8-npt-steam-port-adapter-top-radiator-ls-swap-coolant.html works really well .
  11. reaper mech

    🔧 BUILD 1967 Camaro Turbo LS Build

    really liking that hood !! who made it ?
  12. reaper mech

    🔧 BUILD the odd turbo 2nd gen camaro

    updated op with a few more pics of progress , hope to get the steering rack on next and finish out some of the plumbing
  13. reaper mech

    🔧 BUILD the odd turbo 2nd gen camaro

    lol , if this would have been brown i would have named it the turbo turd , since its blue idk about naming it
  14. reaper mech

    Mavns Sloppy 94mm sbe 6.0 build

    love this build !!! 4th gens tend to get a bad rep sometimes what catch can is that ?