4V - Teksid, 2004 Heads, 2004 Cams, ECU, Aviator Intake, T-45, Cobra Inj/MAF

4V - 2004 Heads/Cams, Aviator Intake, T-45, Cobra Inj/MAF,2V & 4V Crankshafts

All in NW Indiana, not interested in shipping at this point.

97 Mark 8 cast 6-bolt crankshaft(out of block above, great shape - same as GT 2v crankshaft) $50

2004 Cobra 4v heads - , with cams(Mikey's, 10k miles as I recall - extra set of valvesprings and followers from him as well), followers and lifters, blue stripe good valve guides 40k miles - $800
DSC04238.jpg

DSC04242.jpg



1998 4v heads - complete w/cams, followers and lifters 80k miles - $250

One complete set of primary/secondary chains/sprockets - Best offer

98 front cover - Best offer

Brand New Cobra Crankshaft - chamfered, polished and bagged ready to go $300
DSC04227.jpg


2004 4v Aviator Intake, looks almost like FR500 great for forced induction or NA, complete with 24 lb. injectors, rail, throttle body, etc. $350
DSC04221.jpg


98 T-45 w/cable speedo&VSS drive $350

03 Cobra Injectors & MAF $150
DSC04216.jpg

DSC04217.jpg


01 Cobra PCM Harness(needs some repair) $100

2001 Cobra PCM $100

New FMS Cobra oil pan $30
DSC04224.jpg


SOLD 03 Cobra Aluminum Flywheel - Mileage unknown, insert in good shape $50 SOLD
SOLD New 11" Cobra-GT CenterForce Clutch & PP $220 SOLD

SOLD New FMS Cobra oil pump $30 SOLD

SOLD 97 Teksid block that will clean up at .020 over, already cold-tanked - $375 SOLD
firstsvt is going to be building something STRONG!
 

fireball168

Regular
Sep 17, 2005
183
0
REN#4106 said:
Can you pm me the details on the history of the block

Out of a 1997.5 Mark VIII

Bought from Blue Island salvage yard, came out of a rear hit. It was running at the time I inspected it, they pulled it and delivered.

Was correctly disassembled last fall, knocked out the core plugs - sent it out to Van Senus here in Highland, IN(don't have a inside micrometer that goes larger than 3"). They said .020 would clean it up easily. They cold tanked it, and its been bagged up in my heated garage since.

Still have the rods/pistons - the bearings weren't even burnished. Unsure, but may also have the mains for inspection.
 

Thread Info