Figure I'd post this up here, if it violates any rules please take it down.
I'm selling the motor from my camaro when we remove it, I was going to put it in my Burban but I've decided it's too time consuming to perform another swap on a non LS vehicle.
installed with roughly 50k on the clock and it now has a total of 62,864. It gets about 10-12 mpg City and 24-28 Highway mileage depending on driver. Oil pressure 60-70psi cold, 40-50 psi hot @ idle. It will come with a few upgrades that were installed when the engine went in.
The Motor WILL have:
- Patriot LS6 Heads 64cc
- Speed Inc Cam 238/244 .605/.612 110 LSA
- LS6 Intake
- Comp Chrome Moly Pushrods
- LS6 Ported Oil Pump
- Double Row LS6 timing chain with Torrington bearing
- LS7 Clutch & Flywheel
- LS7 Lifters
- Oil Pan
- Valve Covers
- Front & Rear covers
-Throttle Body
- Fuel Rail
- Knock sensors
- Cam Sensors
Will NOT have:
- Headers
- Fuel Injectors
- Crank Pulley
- Dip Stick or Tube
- Accessories i.e... Waterpump, A/C, PS, Brackets, some sensors, Starter, Coil & brackets
Casting number on block
12559378
I'm asking $2500 FIRM
Will throw in the stock K-member for anyone looking to perform a swap into f-body.
I'm selling the motor from my camaro when we remove it, I was going to put it in my Burban but I've decided it's too time consuming to perform another swap on a non LS vehicle.
installed with roughly 50k on the clock and it now has a total of 62,864. It gets about 10-12 mpg City and 24-28 Highway mileage depending on driver. Oil pressure 60-70psi cold, 40-50 psi hot @ idle. It will come with a few upgrades that were installed when the engine went in.
The Motor WILL have:
- Patriot LS6 Heads 64cc
- Speed Inc Cam 238/244 .605/.612 110 LSA
- LS6 Intake
- Comp Chrome Moly Pushrods
- LS6 Ported Oil Pump
- Double Row LS6 timing chain with Torrington bearing
- LS7 Clutch & Flywheel
- LS7 Lifters
- Oil Pan
- Valve Covers
- Front & Rear covers
-Throttle Body
- Fuel Rail
- Knock sensors
- Cam Sensors
Will NOT have:
- Headers
- Fuel Injectors
- Crank Pulley
- Dip Stick or Tube
- Accessories i.e... Waterpump, A/C, PS, Brackets, some sensors, Starter, Coil & brackets
Casting number on block
12559378
I'm asking $2500 FIRM
Will throw in the stock K-member for anyone looking to perform a swap into f-body.
I will let you know what cam I have/had too.. I wanna know.. I think I am gonna hang onto it
