FS: Built Aluminum Short block (mod motor)

Contact: via. PM -Chris

Location: Plainfield

Description: Ford 4.6L , I am changing my set up and I need the cash to do so. More pics available upon request. All work was done at PER race engine. Asking $4500 obo


- .020 over (3.572 in bore) 18cc NEW Manley pistons #594220C-8
- Manley #46620-8 rings file fitted for boost
- clevite 77 rod bearings #cb1442h , main bearings #ms2259a
- Manley H beam rods w/ ARP 2000 cap bolts
- Kellogg 8 bolt crank (internally balanced)
- Bored & honed with torque plate
- ARP main studs #256-5701

Click to read more...

 

[rocket5979]

It's been a few years since I looked at 4.6 mod motor blocks, so forgive me if I do not recognize the block casting from outside the piston valley, but is the block itself an old-WAP, Teksid, or new-WAP S197 Mustang block?

 

[03slomach]

I wana say its the newer s197 style but I can get the part number off of it wednesday or thursday to double check.

 

[Ear Rak]

Easy to tell if its newer-s197....

Does it require adapters for the engine mounts or does it bolt into a 96-04 no problem?

05-10 has a different engine mount/bolt pattern than the 96-04 blocks.

 

[03slomach]

 

[Ear Rak]

Pretty sure 3l2e is newer block.

 

[Teege24]

sooo this is just a stock block with pistons thrown in it...uhhh ill give you $2200?

 

[03slomach]

yep. could you do $2000 and meet me half way?

 

[Teege24]

yep. could you do $2000 and meet me half way?

sounds reasonable

 

[03slomach]

omw

 

[Teege24]

You didn't show....wtf...

 

[03slomach]

bump