follow_along_with_video_below_to_see_how_to_install_our_site_as_web_app
Note: this_feature_currently_requires_accessing_site_using_safari
thought about that, its gonna suck since the hole is so smallOh man...I remember doing this job once...Ill tell you right not, it sucks!!
What I did was drilled a hold right down the center of the bolt and then used a EZ-out to back it out...
thanks! they should be ok but we'll see!I think I have two extra c-clips somewhere if you want them
I was thinking of that, I didnt wanna drill it out because I didnt wanna fuck up the threadsWhen or if your drilling it make sure to keep the drill perfectly straight.. If its crooked the drill bit is gonna be spinning against the threads and then the bolt really wont come out.
That is exactly what happened!here we go..
its a 4 cyl car so no C-clip eliminatorsIf your not gonna get c clip eliminators, atleast get new c clips
allright I tried the magnet... no luck, I tried drilling it out and no luck either, whats the farthest I could drive with no fluid in the diff.?? I have a shop about 5 miles away that I could drive it to and have it fixed, would it be allright?
I didnt think so but I thought maybe cause the gear oil is so thick that it may still lubricateno it would not
thats what I was trying to do but I was trying not to fuck up the threads and I wasnt doin anything. its in a very odd place and there isno room to do itmaybe I am not understanding this...
can ya drill a oversized hole in the bolt, of course your gonna have to replace the pin
hey man, you gotta do what you gotta do, Im still cold and Ive been inside the house for an hour alreadyNice!
esta's fuking loco for doing that chit outside maan.....