Hey all, I am getting close to ordering a floor pan and replacing my drivers side floor, but the way it ripped and rusted, I am afraid of a repeat performance, so I figure if I'm having to weld up these floors, why not weld on subframe connectors with seat reinforcment to help take some strain off the floor pan.
MY question to you all is, Are these subframe connectors too cheap? or are they fine?
http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=LRS-SUBS-RED 1&comp=LRS
they are only 55 bucks, so i'm afraid they're too cheap, but this is a budget build, daily driver, that I plan on tacking to the track once in a while, so they may be all I need, I'm not throwing out huge numbers, or twisting the frame that much, but also I want them to actually STIFFEN the frame, and support the seat, better than nothing.
MY question to you all is, Are these subframe connectors too cheap? or are they fine?
http://www.latemodelrestoration.com/iwwida.pvx?;item?item_no=LRS-SUBS-RED 1&comp=LRS
they are only 55 bucks, so i'm afraid they're too cheap, but this is a budget build, daily driver, that I plan on tacking to the track once in a while, so they may be all I need, I'm not throwing out huge numbers, or twisting the frame that much, but also I want them to actually STIFFEN the frame, and support the seat, better than nothing.