3800 pulley changes
- Thread starter preussenGTP
- Start date
u should be fine depending what condiation the equipment was in before. does anyone have the dub system, mine istarting to crossthread a little in one of the bolt holes has anyone had this happen to them, im very careful everytime, i knwo i never didanything to fuck it up , but sometimes it stops and doesnt want to go in, then i back it out and its a little easier to get it in
A pulley will never get loose.
These are pressed on at the factory so they will always be hard to get on and off. No matter how many times you press it on or off.
Now you will probalby cause a lot of stress on the shaft of the sc and also stress on the pulley which could lead to premature failure.
Odds are they wont even notice a 3.4" press on pulley.
These are pressed on at the factory so they will always be hard to get on and off. No matter how many times you press it on or off.
Now you will probalby cause a lot of stress on the shaft of the sc and also stress on the pulley which could lead to premature failure.
Odds are they wont even notice a 3.4" press on pulley.
