Found a pretty decent deal on a set of CNC heads and Thrasher cam pretty cheap on GPF.net.
Last I looked and compared the Thrasher cam is slightly bigger than the IS3 cam.
Thoughts? Anyone else used this cam?
Would replace the S1X cam that's in the Gen5 E85 setup....
Think I could make 350whp with that Thrasher cam and CNC heads pretty easy.
That's only asking to pick up 20 whp over the S1X cam but I'd like to try a different cam so........
Last I looked and compared the Thrasher cam is slightly bigger than the IS3 cam.
Thoughts? Anyone else used this cam?
Would replace the S1X cam that's in the Gen5 E85 setup....
Think I could make 350whp with that Thrasher cam and CNC heads pretty easy.
That's only asking to pick up 20 whp over the S1X cam but I'd like to try a different cam so........