So im putting together a cobra motor,
I have an iron block with forged internals that i need taken apart/inspected to see if it has spun bearings, also debating weather i should stick with the stock pistons or go diamond?
04 cobra heads that i would like to get ported/polished and have some turbo cams installed. I basicly need everything taken apart and put back together with good parts. This motor will be pushed hard by two turbos so i would like it to hold up to at least 1000hp. Any recommendations on which shop to go to would help me out a lot.
I have an iron block with forged internals that i need taken apart/inspected to see if it has spun bearings, also debating weather i should stick with the stock pistons or go diamond?
04 cobra heads that i would like to get ported/polished and have some turbo cams installed. I basicly need everything taken apart and put back together with good parts. This motor will be pushed hard by two turbos so i would like it to hold up to at least 1000hp. Any recommendations on which shop to go to would help me out a lot.