I left the picnic today a little early so I could mount my new MT DR 315's. They are no were near the same size as my 315 nitto's. They fit on my car no problem. I'm running MM 1" wheel spacers, 3" studs, and MM low profile IRS bolt.
After I got them mounted I took it out for a test drive. I drove about 3 miles or so, then I gave her hell...Ripped first and both spun then grabed 2nd gear and my car wheel hopped bad so I got off it. I was totally not happy.
I got home check the tire pressure, they were at 38ish or so..I was WTF so I backed them down to 30psi. I haven't taken the car out yet to see. I really didn't think they hooked good at all. I will take the car out later this week and rip some gears. I will get pics up tomorrow.
What PSI is everyone running them at?
Kevin
After I got them mounted I took it out for a test drive. I drove about 3 miles or so, then I gave her hell...Ripped first and both spun then grabed 2nd gear and my car wheel hopped bad so I got off it. I was totally not happy.
I got home check the tire pressure, they were at 38ish or so..I was WTF so I backed them down to 30psi. I haven't taken the car out yet to see. I really didn't think they hooked good at all. I will take the car out later this week and rip some gears. I will get pics up tomorrow.
What PSI is everyone running them at?
Kevin