I have a set of machined knobs on the HVAC in the GTO. They are quite nice but are smooth and sometimes can be a PITA to control because they are slippery.
I was thinking that knurling the outside edge would both look nice and be functional. Does anyone have a lead on where to get this done? These are Solid Aluminum Billet and the inside has a taper so that might present a challenge...
Thanks,
John
I was thinking that knurling the outside edge would both look nice and be functional. Does anyone have a lead on where to get this done? These are Solid Aluminum Billet and the inside has a taper so that might present a challenge...
Thanks,
John