front control arm bushings

Mystic Terminator

TCG Elite Member
Oct 6, 2004
3,150
0
Don't do it, I highly doubt it will make a difference. Plus I believe they have to be pressed out.

My control arms were more work than the IRS cradle bushings. I had to burn them out and it was a bitch. It was very time-consuming to do it all. Do not use urethane for an articulating joint, use delrin. FRPP sells delrin bushings for the control arms.

They also sell extended ball joints (Like the Steela X2) that you can do @ the same time.
 

Jimy Bilmo

CSVT OG Member
TCG Premium
TCG Goldmember
Aug 16, 2005
38,139
59,529
thArnold_Carrot.gif
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info