follow_along_with_video_below_to_see_how_to_install_our_site_as_web_app
Note: this_feature_currently_requires_accessing_site_using_safari
get rid of retracts with that stuff, i had the same thing, gets really bad with the yellow /gold color of the ttyt3d.
it cooks insid ethe hotend and the retracts especially multiple retracts cause it to stir crap up near the heatbrake and clog the chamber nozzle
the best soltuion was the removal of retracts and selecting hiding the Z seam in cura.
print test towers till you get it close (upside down table/row of towers tests you can DL off of thingiverse)
The skr board was hands down the best purchase. Dont go with the creality silent board.I think I need to finally get my printer quiet.
You got the full screen too right?The skr board was hands down the best purchase. Dont go with the creality silent board.
Bit of a install, but so worth it.
Yup but honestly the screen isnt needed and had half ass support in marlin...at least 6 months ago it did, i havent checked recently.
Did you try foam blocks under a concrete block yet? Seems like a cheap investment before doing a board.
Sweet.Best enclosure is printer enclosure from the start...... a circa 2003 dot matrix printer.... Printronix PSA p5205b gutted.
It sound dampened and has an external power switch a high-quality one at that.... front and rear mag sealed doors and mag sealed lid for sound/air tight operation.... once the air cooling holes are blocked off
For the Tevo Nereus? ....but likely it'll be our heated/dried fillament cabinet
View attachment 86661