Lots of good mustang PUSHROD HP parts for sale..

Most of the parts are still on the car and running. Some parts are brand new. Please email if interested.

Will not respond to PM's or posts

[email protected]

Follow parts are used but in good condition

Trickflow Trackheat intake $350
BBK 75mm tb and spacer $200
Aeromotive fuel rails $100
50lbs MSD injectors and 83mm Pro-m MAF $500
1 3/4 long tube BBK ceramic coated headers $250
42lbs Lucas injectors and 80mm Pro-m MAF $425
Ford Motorsport SVO 1.7 stud rockers $150
Pre-04 PMS with 3bar map $500
Aeromotive A1000 pump with filter $250
80mm Pro-m meter for renegade (electronics dont work) $100
A9l Computer and MAF harness $100
5 gallon aluminum fuel cell $100

347 low compression motor with eagle H-beam rods, eagle 4340 crank, JE pistons, and CHP main support. Entire motor is studded (mains and head studs), comp blower cam, canton oilpan, roller timing chain, and edelbrock waterpump. Motor was built by Opel Engineering. $2000

TFS twisted wedge heads off above motor with rocker studs and guideplates. $900

Vortech YS trim drivers side. Kurgan motorsports dual bracket setup, 8inch 8rib crank pulley and 2.85 upper. $2000

NEW PARTS
Vortech MONDO cooler for TFS "r" lower (still in plastic) $1800
Snow performace stage 2 boostcooler off MAF voltage. Still in box $350
Vortech Strut brace between crank and supercharger pulley. Includes all parts to make it work $400.
TFS track heat lower still in plastic $200

thanks bob
 

Thread Info