Billetflow IRS Sub frame Support Brackets

Sold ~ Sold ~ Sold​

Billetflow IRS Sub frame Support Brackets

Material: 1018 Mild Steel

Misc: 3 Hole Design(50% more attachment points)

Custom Backing Plate: (the only Bracket on the market with this feature)

Hardware: Grade 8 Fasteners included

MSRP: $49.00

Link

Local sale pick-up $35.00
Delivered to MSC 4.0 / SVTOA Putnam Park $35.00
Shipped UPS $40.00

Reason for sale: I won these @ MSC 3.0 and I went a different route. These are way better than the Steeda IRS Subframe Brackets.

Click to read more...

 

[Red89gt]

Vince,

What are these things for?

What do they support/reinforce?

Chris

 

[Mystic Terminator]

Vince,

What are these things for?

What do they support/reinforce?

Chris

Stiffen and support IRS Carrier. Reccomended by William Mathis.

Next, fabricate a bracket from 1/8" x 3" Flat ASTM A108 steel that will be welded to the outside edge of the rear subframe mount bracket and extended up inside the wheel well to a point approximately 1.5" above the level of the trunk floor. Drill two 3/8" holes through the bracket and wheel well into the trunk area, approximately 0.75" above the trunk floor. Install grade 8 bolts, nylon insert nuts and W series, type B, washers. You will have to massage the plate to conform to the wheel well.

http://corner-carvers.com/forums/showthread.php?t=6249

Sold by Steeda and Billetflow. Needs to be bolted in and then welded. An hours labor to bolt in, and then take to your fav. muffler or speed shop to have it welded. 2 four inch welds shouldn't take too long to weld.

Vince