Turbos for sale

I have access to a few of these turbos. I do not know much about them, other than they are honeywell/Garrett, and were run for less than 2 minutes to test a C13 diesel

I tried to get pics of the A/R rating and the serial numbers. My neighbor would be able to answer any questions for you better than I could. If anyone can decipher the numbers, or knows more about these, let me know, or comment in here. I believe that they would work best in a drag racing, or big turbodiesel (i.e. power stroke). They go for about $2500-2800 new. Asking $750/obo P.M. me if you are interested.

Click to read more...

 

[bigbademan]

ttt

 

[boogeyman]

these are for a c-13 acert correct ?

 

[Burtonrider10022]

I think these would be overkill for my 2L 4cyl.

Free bump.

 

[bigbademan]

these are for a c-13 acert correct ?

Yes they were originally, Can't seem to find the specs for them, so I am not sure how they will work in other applications.

 

[boogeyman]

Put them on Craigslist that's your best bet

 

[heartbreaker68]

can U by chance measure the inlet and outlet... in mm please..!?? I would like to swap 6 liter turbo with something larger! and depending on size and cfm, I may b able to use on the new notch build...

 

[boogeyman]

Those turbos are something like 1.32a/r exhaust and setup in a sequential manner. You want the atmosphere turbo but i don't think they will work very well for you and they have a odd dual scroll turbine housing with triangle shaped ports. On a BBC with 496+ cubes they might be OK but if I remember right they are like 94mm exducer size so it would take massive rpm or lots of cubes

 

[bigbademan]

Sorry I've been out of town. I'll try to get the measurements tonight for you.

 

[bigbademan]

Here are the measurements

71mm ID

120mm ID

Each port is 60mm across and 48mm from the bottom center to the top center


Hope this helps

 

[boogeyman]

were u measuring the outlet flange or did u take the compressor cover off the turbo and measure the front smaller diameter of the wheel and the rear large diameter of the wheel it should measure out something like 84mm inducer (front) 120mm exducer(rear)

 

[bigbademan]

Ill have to take your word on that, as I do not want to take it apart.

 

[DIVINE]

These would be great on a big inch motor but keep in mind that it came off of a 3406 CAT. I think that is a 800-850 cubic inch diesel. But it only spins roughly 1600 rpm. The turbo is usually spooled up to 80,000 rpm by 1,000 rpm on the motor. I've always wanted to try out one of these turbos on an LS engine running closer to 7,000 rpm. Good turbos. I've worked on a lot of the 3116 and 3126 turbos.

 

[DIVINE]

I guess I should also add that these turbos are usually good for over 800,000 miles.

 

[Turbocharged400sbc]

if santa left one next to my garage door id be inclined to put it on my 460

 

[bigbademan]

If Santa can give me $650.00 cash money, It'll be under your tree.

 

[bigbademan]

TTT Price reduced to $650.00