I have this up on CGP too, but I'm asking only $150 here:
LS1 TB with adapter for gen 3 blower. It has been modified with a throttle plate from an l32 TB (thinner than LS1plate). It also has no hole in the plate. I opened up the IAC channel a little bigger so the plate does not need the drill hole. The IAC valve is 3 months old. I powdercoated the linkage and adapter plate. The PCV is FULLY functional on this set-up. On the commercial LS1 kits this was not functioning. I also ported and smoothed the inlet. The TPS connector adapter is included.
I will do $150 shipped on it.
On the car pic:
LS1 TB with adapter for gen 3 blower. It has been modified with a throttle plate from an l32 TB (thinner than LS1plate). It also has no hole in the plate. I opened up the IAC channel a little bigger so the plate does not need the drill hole. The IAC valve is 3 months old. I powdercoated the linkage and adapter plate. The PCV is FULLY functional on this set-up. On the commercial LS1 kits this was not functioning. I also ported and smoothed the inlet. The TPS connector adapter is included.
I will do $150 shipped on it.
On the car pic: