snow performance water/meth kit stage II boost kit.

Stage 2 MAF Boost Cooler™

This kit uses the 0 to 5 Volt output signal from the Mass Air Flow sensor on many fuel injected vehicles. This means that any vehicle with a MAF (with a 0-5V output signal) can use this kit, whether they are naturally aspirated or forced induction. If the application is forced induction, it can be used with very fast-spooling turbos, or positive displacement blowers. It is easier to set up with the positive displacement blowers with a MAF signal because it is more progressive in nature vs. the boost pressure signal on those applications. This allows for accurate injection over a wide range.

this was mounted and never used. 325obo.

Click to read more...

 

[sleepercobra]

hmm, i wonder how much my car would benefit from this.... what car did you have it mounted in?

 

[deviantlx]

hmm, i wonder how much my car would benefit from this.... what car did you have it mounted in?

thats the problem, my car isn't mass air. its speed density. lol.


i bought the car and the previous owner installed this kit but never used it.



my kit is the stage 2 mass air kit.


http://www.snowperformance.net/product.php?pk=9http://www.snowperformance.net/dyno_chart_view.php?type=gasoline&dck=6

 

[Rafal@LastDetailAutoSpa]

I had this kit on my Lightning... with a 6lb lower pulley and supporting mods on a stock eaton it didn't do much to be honest and Bob tuned it (it was gain of maybe 5 hp)... however it was nice safety measure and cooling technique. Generally turbo, diesel, or high boost vehicles will benefit more from methanol. Great kit though and super easy install!

Rafal

 

[deviantlx]

somebody buy me!