FS/FT: 2002 Subaru WRX jdm sti swap gt35r

14k obo

Up for sale is my*2002 Subaru WRX with a JDM STI/STI motor swap and a JDM Spec C RA transmission FULL STI interior with custom suede pillars and headliner.
*
I consider the car an Sti, its more than fully swapped. It is currently 98 percent complete, all it needs is a final tune and it’ll be putting down 400-500 horsepower at ALL 4 wheels depending on how much*boost you decide to run and if you run methanol. That being said, the car is on a BASE TUNE right now... I have been babying the car, driving it to 3000 rpm’s and not getting into boost at all so I didn’t do any damage to the motor. Here is a list of the modifications, Ill give a full list of problems after the modifications
*
I’m really looking to sell or trade the car. I'm open to pretty much any trades of equal or less value... If less I would of course need cash on top... I am also open to takeong parts for partial trade... I will make a list at the bottom of this post of car parts I am looking for currently.... I have a lot of money invested into my car so I don’t want to give it away, I don’t mind driving it or holding onto it at all...
*
The shell has 70,000 miles, the block and heads were bought brand new and have about 15,000 miles on them, and the transmission has 15,000 miles as well. Everything else on the car is basically brand new, newly fabricated, or has less than 8,000 miles...
*
*
VIN: JF1GD29692G511342

*
ENGINE:
EJ207 Ver8 JDM Sti Short Block
05 2.5 Sti Heads
TGV Deletes
5 Star Fabrication Sheet Metal Intake Manifold
Custom Throttle Body Spacer
Grimmspeed TGV Deletes Welded onto the Intake Manifold Runners
Grimmspeed 8mm Pheonolic Intake Manifold Spacers
Blow-thru MAF Setup
Perrin Fuel Rails
Modified Stock Injectors to 820cc Injectors
Garret GT35r .82 a/r
UR 2.5" Rotated Uppipe
Tial 38mm EWG (External Wastegate) with Dump tube
Custom rotated downpipe
Perrin 4inch Turbo Inlet
MRT Front Mount Intercooler with Custom Intercooler Piping
Tial 50mm Bov
Perrin Radiator Hoses
Fumoto Oil Drain Valve
Gtspec UEL Header
Aps 3.5 Catback Exhaust
Kartboy Extended Exhaust Hangers
Cobb Oil Cap
Battery Relocated to Trunk
Windshield Wiper Fluid Reservoir Deleted
Stainless Braided Power Steering Line
*
SUSPENSION:
Tein Flex Coilovers
Tein EDFC
Whiteline Rear Sway Bar
Whiteline Rear Endlinks
Whiteline Rear Camber Bolts (not installed yet)
Front and Rear Strut Tower Bars
Agency Power Pitch Stop Mount
Paranoid Fabrications Fender Braces
*
*
BRAKES/DRIVETRAIN:
JDM Spec C STI RA tranny
STI Factory Short Shifter
STI Solid Tranny Mount
ACT Clutch
ACT Streetlite Flywheel
Stainless Braided Clutch Line
*
*
EXTERIOR:
Side Skirt Spats
Rear Lip Kit
Rear Diffuser
Painted Sideskirts
Blacked Out Bugeye Retrofitted Headlights
-Acura TL Projectors
-ZKW Projectors(for the lens)
-Digital 55w Ballasts and 55w 5000k Bulbs
-Custom Shrouds
04/05 Tail Lights
--JDM Modded
Carbon Fiber STI Sidemarkers
Seibon Carbon Fiber Hood
Seibon Carbon Fiber Trunk
Mines Carbon Fiber Replica Spoiler
Tein Hood Dampers
Hella Supertone Horns(LOUD)
*
INTERIOR:
04 STI Front and Rear Seats
04 STI Door Cards
STI Chrome Inside Door Handles
05 STI Gauge Cluster
HVAC and Other Interior Lights Converted to Red
STI Shifter Trim
04 STI Ebrake
Greddy Counterweight Shift Knob
Garage Spec Shifter Extender
JDM STI Red Hazard Button
Kakamuei Carbon Fiber Clock Pod
Prosport 60mm Electric Boost Gauge
Prosport 60mm EGT Gauge (needs sensor installed)
AEM Wideband A/F Gauge
Custom Headliner Wrapped in Black Ultrasuede
Custom A,B, and C-Pillars Wrapped in Black Ultrasuede
Pioneer CD player
*
WHEELS:
Rota G-Forces 18x9 +35--Gold
--235/40/18
Rays Extended Lugnuts Powdercoated Red
Rear Quarter Panels Rolled Flat-ish
Front Fenders not Touched at all
*
THE CAR HAS A BRAND NEW PASSENGERS SIDE FRONT WHEEL BEARING... LESS THAN 50 MILES
*
IM SURE THERE ARE A FEW THINGS IM FORGETTING ON THE LIST
*
Here is a list of the CONS:

-The car needs a final tune
-The body has various scratches and dings (mainly on the rear bumper and drivers side skirt),*also there is a dent on the drivers side rear quarter panel (somebody backed into my car 2 days after I got that entire side of the car painted) I GOT QUOTED 490 TO PULL THE DENT AND FIX ALL THE DINGS/SCRATCHES AND REPAINT EVERYTHING THAT WAS FIXED

list of car parts I'm looking for: (everything is for an '03 cobra unless otherwise noted)
2.6H/2.8H Kenne Bell
crower stg 3 cams/cam kit
Bassani mid-lengths
Bassani X-pipe
85lbs injectors
Viper Spec t-56
sheetmetal innercooler reservoir
Corbeau gts II seats
S.O.S 10 pt cage for a fox
smoked headlights for a fox
black door panels for a fox
black headliner for a fox
black rear plastics for a fox coupe
any black trim pcs for a fox interior
Florida 5.0 gauge cluster for a fox
cobalt gauges
I'll add more parts to the list as I think of them...
wrx.jpg


255f882e.jpg


2ccb1f5e.jpg


73ff12d4.jpg


8dcdab92.jpg


7f390373.jpg
 

sayno2rice

Member
Oct 30, 2005
32
0
Sorry price added to original post.... I took the car on a trade w 12000 miles on the new motor and I have put approximately 3k miles on it just as my daily driver and yes I never drive the car hard and he drove it just as easy as his daily... He took it to have it tuned and they told him to reroute some of the innercooler piping and the drain flange on the turbo was leaking so he fixed this things and got burnt out so him n I worked out a trade... I was gonna have it tuned but have to many projects and my termi fox is first on my priority list... Let me know if u have any other ?'s....
 
not trying to be downer on the sale, but a word of caution the buyer... make sure you can pass emissions with with JDM motor, as it can lack some US sensors needed to pass emissions. I know the thread states that it's just a JDM short block, but I ended up putting a Ver 7 short block in my subaru before and there was no way it would have passed emissions legally in Dupage county. Oh, and no air bags for you or your passenger...nice car nevertheless!

Rafal
 

Thread Info