DIY 2/ Smoke-CO2 detector

Xtant12

TCG Elite Member
May 31, 2007
3,318
67
I have smoke detector/co2 wired to the house. I have a total of 3. I found an orange wire tucked into the conduit and am not sure what it is for. I discovered it because I have to add a 10 inch wall plate to cover the drywall being cut a bit to big. I was able to pull the wire out and it is connected to something because it did not come out when I pilled it. Other detectors had it also. Any ideas??
 

Xtant12

TCG Elite Member
May 31, 2007
3,318
67
You need to work on your thread titles man. Make them more specific.

“I have a question about smoke detector wiring”
“Is anyone familiar with hardwired smoke/CO detectors?”

Etc.

after digging into it, you guys are right. So I now need to send a signal and see if they are even connected to anything or if there is a break in the wire. I will let you know how it goes!
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info