Haven't posted in a while, ran into a lot of issues with my other project. Hopefully this one goes much better. Long story short: I bought an 86' Camaro last year, drove it for a bit, had some electrical issues and let it sit all winter. Began tear down in the spring, pulled the carpet back and found some serious rust. Holes in the fire wall and floors, they were covered with pop-riveted in sheet metal. I was pretty pissed.
Here are some pics:
More than what I was willing/capable of fixing. (side note, I will be getting rid of it, if anyone is interested message me)
So, after serching for a clean car, I picked up an 84' Z28. Most of the body issues have already been fixed.
Here it is:
The car was in Florida for most of its life, so no serious rust, just a few small spots. It has a 4th gen rear end and new suspension all around. No engine or trans, but I do have an Lt1 with a stroker kit that I will be dropping into it, that was the only good thing that I got out of the 86'.
Here are some pics:
More than what I was willing/capable of fixing. (side note, I will be getting rid of it, if anyone is interested message me)
So, after serching for a clean car, I picked up an 84' Z28. Most of the body issues have already been fixed.
Here it is:
The car was in Florida for most of its life, so no serious rust, just a few small spots. It has a 4th gen rear end and new suspension all around. No engine or trans, but I do have an Lt1 with a stroker kit that I will be dropping into it, that was the only good thing that I got out of the 86'.
