TH400/Gear Vendors install thread
I got the 4r70w out yesterday without issue, and realized quickly I couldn't lift the TH400/Gear Vendors up on the trans jack myself, so I did the shifter for now.
I didn't think id commplete it in a few hours (less wiring) but I did.
I'll post pics of the trans install here, as well as crossmember modification.
For now, here are the shifter pics:
Here is the console bottom assembly with threaded rod binding posts welded on. Easy to get the height correct with them
I used a sharp punch to puncture the floorboard from inside for the shifter cable:
I later used a piece of small vacuum line to act as a grommet for the hole.
I have to make a trim plate or have a new shifter boot made to take up the gap
And the installed view underneath. I can't believe how smooth everything went
Now I can swap the good driveshaft I took out of this over to my Blue MM.
I got the 4r70w out yesterday without issue, and realized quickly I couldn't lift the TH400/Gear Vendors up on the trans jack myself, so I did the shifter for now.
I didn't think id commplete it in a few hours (less wiring) but I did.
I'll post pics of the trans install here, as well as crossmember modification.
For now, here are the shifter pics:
Here is the console bottom assembly with threaded rod binding posts welded on. Easy to get the height correct with them
I used a sharp punch to puncture the floorboard from inside for the shifter cable:
I later used a piece of small vacuum line to act as a grommet for the hole.
I have to make a trim plate or have a new shifter boot made to take up the gap
And the installed view underneath. I can't believe how smooth everything went
Now I can swap the good driveshaft I took out of this over to my Blue MM.