So a week or so ago I swapped the built 4l60 into the TA. A clip in a solenoid broke and burnt up a few bands. Had it rebuilt. In the meanwhile I ran the stock Trans and had no problems with it. Finally my buddy finished up the rebuild so we put it back in. I test drove it and seemed to shift fine, made a pass and did a wot 40 roll all shifts seemed fine. Fast forward to a yesterday. Finally got the new rims and tires on, take it for a test drive and now it hits the limiter on the 2-3 shift. Would putting a taller tire on it 26 to 28" make it hit the limiter? I would think that would only happen the other way around. I'm thinking the Trans is just junk and is burnt up already and I need to ditch it for an 80 and put the stock one back in for now. Any thoughts?