• đź’ˇ Fun fact. Whenever you start a thread, TCG Mechanic 5000 (our AI bot) will reply to you to start helping. It doesn't know everything and it will struggle with more complex questions but it can get the thread going and provide valuable information. You can choose to disable it prior to submitting a thread.

Pulling off a pulley from a KB...

Flatliner

I'm kind of a big deal...
Mar 3, 2004
35,000
0
From mf: http://www.modularfords.com/forums/f17/anybody-have-kenne-bell-removal-tool-49635.html

...You could make a pretty good one with a length of aluminum bar stock, like a piece of an aluminum yardstick and a couple of appropriate size bolts and nuts. You need to drill a hole in one end of the bar big enough to put your allen wrench thru, and two smaller holes on either side of the bigger hole. Secure the bolts on the bar with the nuts, insert the bolt ends in the index holes in the pulley, insert the allen wrench or hex driver thru, and turn while holding the bar...
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info