whipple 3.4?

[onecobra2fear]

I keep seeing post and people talking about whipples new blower, but when I go to their web site all I see is the 140x, some one please enlighten me.
thanks

Click to read more...

 

[onecobra2fear]

I keep seeing post and people talking about whipples new blower, but when I go to their web site all I see is the 140x, some one please enlighten me.
thanks

has anyone seen or heard about this 3.4 whipple blower??

 

[hj16]

has anyone seen or heard about this 3.4 whipple blower??

Yes.

I believe its release date is set for the 3rd week of April. Reports directly from Dustin@Whipple are that there is no point to run this blower if you want to run 17psi or less...that the 140AX is the better choice, and that the 3.4L only really shines above 20psi.

 

[onecobra2fear]

Yes.

I believe its release date is set for the 3rd week of April. Reports directly from Dustin@Whipple are that there is no point to run this blower if you want to run 17psi or less...that the 140AX is the better choice, and that the 3.4L only really shines above 20psi.

thanks, I looking to make 550-600rwhp. I currently @ 517 w/ my heaton

 

[Bob_Kurgan]

thanks, I looking to make 550-600rwhp. I currently @ 517 w/ my heaton

get the 140 then.. i just tuned a 140 on a built 4v 03/04 cobra with cams and bottom end... with 14psi, it made over 650rwhp... with 20psi, should make 725rwhp.

 

[hj16]

thanks, I looking to make 550-600rwhp. I currently @ 517 w/ my heaton

The 140AX is the Whipple blower you want then.

If you dont have a brand preference I'd suggest a used 2.2L KB, with the introduction of the new 2.6 and 2.8 blowers you can pick up used ones for as low as $2100

 

[hj16]

get the 140 then.. i just tuned a 140 on a built 4v 03/04 cobra with cams and bottom end... with 14psi, it made over 650rwhp... with 20psi, should make 725rwhp.

Jeez, what else does it have done? What was it pullied for? 650rwhp reading 14psi is nuts!!!

 

[Bob_Kurgan]

Jeez, what else does it have done? What was it pullied for? 650rwhp reading 14psi is nuts!!!

it was pullied for 17-18psi... had a built bottom end, cams, and massaged heads... then your normal bolt ons like ba2400, 60lbs inj, dual gt pumps etc.... ended up pegging the maf at a little over 650rwhp... putting a mafia on it and putting race fuel in it... that was on 93octane... it was actually 14psi at peak tq and only 12.5 at peak hp (7,000 rpm)... will keep ya updated!