Need info on where to straighten axle...

[grey03svt]

Putting a solid axle in the 03 cobra. I need to know who can straighten the axle tubes, and weld them to the housing. Im in NW Indiana tri-town so, maybe there is one close by?

Thanks guys.

Click to read more...

 

[dun4791]

I could help you out, how bad is the assembly? The shop is in Beecher. Let me know
Lyle

 

[grey03svt]

The assembly is not bad at all. It was out of an 04 Gt, that had 1500 miles on it. The tubes look like that have a slight curvature to them. Other than that, I just need them welded to the diff. housing.
Usually you straighten/weld the tubes in a high HP car, correct?

btw, I have a couple of pics if you wanna see them.

 

[dun4791]

Why dont you give me a call this weekend.
Lyle

 

[02RedL]

Lyle to the rescue again! Dude honestly, if you need that rear end taken care of with welding involved, this guy is your man! :biggthump

 

[grey03svt]

Will do, thanks man! :biggthump

 

[Dana]

Is the housing empty?

Do you plan on going through it before you install it?

Dan

 

[grey03svt]

Is the housing empty?

Do you plan on going through it before you install it?

Dan

Yes it's completely empty. There is a couple of bearing/seals that are still in, but I am replacing them with all anyway.

I plan on mimicing Postban's "Blue Pill" built 8.8. http://www.svtperformance.com/forum...914 b6bda9a3eae1b4c6f722a82058&threadid=94768

 

[grey03svt]

Is it really nessecary for the axle tubes to be straightend? like I said before, the tubes have a slight curvature to them, but i was checkin out an 05 Gt and it kinda looked like the same curve... I am not sure though.... What you guys think??