ordered my Liberty input shaft today

[chris@svtspeed]

Just ordered my liberty 26 spline input shaft still not sure what clutch to go with. Im leaning towards the ceneter force dual friction but thinking about the DFX by centerforce.

:headbang:

Click to read more...

 

[Juggernaut]

what kinda stage upgrade is that!?

 

[gnxs]

Just ordered my liberty 26 spline input shaft still not sure what clutch to go with. Im leaning towards the ceneter force dual friction but thinking about the DFX by centerforce.

:headbang:

I suggest Dual-Puck or DFX. I wouldn't go DF with your power (and tq. ).

 

[chris@svtspeed]

I suggest Dual-Puck or DFX. I wouldn't go DF with your power (and tq. ).

I think I may go DF for now and one day when I do the whipple I will go with the DFX

 

[chris@svtspeed]

what kinda stage upgrade is that!?

well the output shaft in a stock t56 is 10 spline the liberty shaft is 26 spline much stronger then stock.

 

[Juggernaut]

whats the stock spline? on these rides?

 

[chris@svtspeed]

whats the stock spline? on these rides?

stock spline is 10

 

[chris@svtspeed]

now im excited I ordered my center force clutch and spec flywheel today so I think I have everything I need to do the install.

 

[gnxs]

I think I may go DF for now and one day when I do the whipple I will go with the DFX

I know the DF have been holding up to some good power too.

Just an FYI, my dual-puck setup is 100% streetable (better than stock actually) and has been holding up fine.

 

[chris@svtspeed]

I know the DF have been holding up to some good power too.

Just an FYI, my dual-puck setup is 100% streetable (better than stock actually) and has been holding up fine.

does it chatter at all? can you slip the clutch at all?

 

[ShelbyGuy]

does anyone have an end play checking tool already made (as listed in the instructions)?

 

[dun4791]

Dial indicator is what I used-but I havent heard of anyone having any trouble with the Liberty-My endplay was better than stock. You could probably get away with trusting the machining from Liberty..................Lyle