đź’ˇ Fun fact. Whenever you start a thread, TCG Mechanic 5000 (our AI bot) will reply to you to start helping. It doesn't know everything and it will struggle with more complex questions but it can get the thread going and provide valuable information. You can choose to disable it prior to submitting a thread.
Anyone have a clutch alignment tool for the stock input shaft and or a flywheel turner i can use soon? I thought the alignment tool came with the DF not the case.
yes the input shaft tools are cheap but borrowing one is free. Im gonna use Danas old 10 spline input shaft. And yes id like to get the flywheel tool Where do you usually go back n forth to work at? If you arent too close to get it ill just try to use a piece of wood to wedge it from turning.
I think I have 1 or 2 clutch alignment tools. One is the plastic and I believe the other one is aluminum w/ assorted bushings if I recall correctly. Still looking?
I work from home. Hence the steady diet of government cheese and living in a van down by the river. If you were to say, have a couple beers with me over at Kelly's, I could be persuaded to bring it....
dun4791 said:
yes the input shaft tools are cheap but borrowing one is free. Im gonna use Danas old 10 spline input shaft. And yes id like to get the flywheel tool Where do you usually go back n forth to work at? If you arent too close to get it ill just try to use a piece of wood to wedge it from turning.
Ya is Kelly actually working on those Cougars now? Sounds like a plan, id like to see the garage, been a while since i was there. The loft should be done by now huh?