PIC REQUEST (rear seat area 99-04 lower cushions out)

3v2000GT

TCG Elite Member
May 7, 2007
1,217
0
there should be two bolts that attach the seats to the car at the top and at the bottom, and three that attach the plastic "head rest" peice to the rear seats. sometimes you have to mess with them a little to get them to line up right. I have to drill new holes to attach the rear seats at the bottom, for some reason my new seats are a little different than the ones you have.
 

3v2000GT

TCG Elite Member
May 7, 2007
1,217
0
That must be the problem, mine are off too! The studs wont line up so I bet yours would fit mine, but not vise versus! Wanna switch frames! HA!

JTR

if thats the case i wouldnt worry about it, if the tops line up then it should be fine, ill probably drill the holes when i get bored, cuz its like 1 in 100 chance of someone sitting in the back
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info

  • 03GEETEE
    Created
  • 4
    Replies
  • 309
    Views
  • Participants list