Finishing up a little somethin somethin for my camaro. Putting the finishing touches on a run of the mill 350 w/ 4 bbl carb and am looking to have Dyno tested before it goes in the car just to have run and make sure all of the kinks are out. Would prefer over a run stand because would like to see some numbers but will settle for it if need be. Should have it operational by February. any suggestions?
Ps. Engine is in Hanover park and can be transported locally. Hoping to make this as cheap as possible
Ps. Engine is in Hanover park and can be transported locally. Hoping to make this as cheap as possible