picked up a new motor today....

phat_ridegt

TCG Elite Member
Sep 16, 2007
3,351
2
Ottawa
i picked up a motor today from a guy in merrillville....

its an L67, that has been balanced, including balancer and flexplate, also has ARP main studs, rod bolts, and head studs....has all new bearings as well. factory pistons/rods, just balanced, the deck was milled less than 5 thousanths to clean it up....my camera took a crap but heres a couple pics from my phone

bottomend.jpg

engine.jpg
 

32vMonte

Car is broke
Dec 3, 2008
774
50
itll probably blow up...but not because the engine failed...because i put too much power to it!

built 3800 dont last...but this isnt built...no machine work on the crank, cylinders, or block...just balanced, and using good hardware. a reputable shop in indiana did the work...

Yea which one. I just was curious. I've had engine work done at a couple of places around here.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info