MIL Eliminators installed and don't work

Angus

TCG Elite Member
TCG Premium
Oct 12, 2007
11,796
862
HHI, SC
SES light pop up for 4 codes:
P0141 - O2 sensor heater circuit malfunction bank 1, sensor 2.
p0161 - O2 sensor heater circuit malfunction bank 2, sensor 2.
p2270 - O2 Bank 1 Sensor 2 Signal stuck lean.
p2272 - O2 Bank 2 Sensor 2 Signal stuck lean.

faaaaakkk
 

Angus

TCG Elite Member
TCG Premium
Oct 12, 2007
11,796
862
HHI, SC
they look like this:
LRS-MIL02.jpg
 

utryd2

TCG Elite Member
TCG Premium
Jul 3, 2009
4,287
304
North Aurora
Those are junk and never work. They have a resister inside, they are meant to plug in betweeen the harness and o2 sensor. I wouldnt mess with mil's anymore. I bought the same set you show on ebay.
On my mustang I went through 3 different manufacturers. None worked. Then bought a diablosport tuner and turned off the rear o2's. Didnt have the problem again.
 

greasy

TCG Elite Member
TCG Premium
Jun 25, 2007
36,909
28,931
Those are junk and never work. They have a resister inside, they are meant to plug in betweeen the harness and o2 sensor. I wouldnt mess with mil's anymore. I bought the same set you show on ebay.
On my mustang I went through 3 different manufacturers. None worked. Then bought a diablosport tuner and turned off the rear o2's. Didnt have the problem again.

I told him this, but he would not listen. :hsugh:
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info