richie rich's lumi pos truly solid mounts

[Turbocharged400sbc]

they dun got filled with urethane for the lumi junk ass 3800 swapage project

just look at all them urethane spooges

for fuckin rusty ass racecar 9c3 3800 swapage awesomeness

for all you other cheep fucks this shit can be dun for you toooooo

Click to read more...

 

[smug]

gimme some of that

 

[frosty23_45]

Can this be done to worn out stock junk, or should you use new mounts?

 

[PANDA]

i haz a FMR MM

 

[Turbocharged400sbc]

i use new cause its cleaner and old worn out junk is just that...worn out junk

 

[frosty23_45]

right, just figured I'd ask. I really need to replace my mounts too. Gotta wait til tax return at the end of the month before I can buy anything though. Thinking about getting either the shorter dogbones or the plates to put on the mounts. Got some vibration after lowering.

 

[Turbocharged400sbc]

lowering these piles of junk just means the axle angles under wot are closer to level (ie no angularity of the cv shafts) than the oem 4x4 heighth

 

[frosty23_45]

Just tired of the vibration under acceleration. Otherwise it's fine.

 

[10sec]

lowering these piles of junk just means the axle angles under wot are closer to level (ie no angularity of the cv shafts) than the oem 4x4 heighth

This is why i never want to do any suspension mods to the rear of my car when i'm at the track. The car squats so much i don't feel the shake under WOT.

 

[Turbocharged400sbc]

you just want to avoid gettin durtay

 

[smug]

This is why i never want to do any suspension mods to the rear of my car when i'm at the track. The car squats so much i don't feel the shake under WOT.

 

[Turbocharged400sbc]

drill a few holes and get some hand strength pumping in thick ass urethane....id prob rip my dick of if i still bait'd nowadays

 

[10sec]

you just want to avoid gettin durtay

No, i did the spacers on the red car along with a new motor mount. The car leaked/leaks a lot of different fluid. There's a permanent stain on the garage floor where i was working from all the shit on the motor mount. Caked on grease. The car is going to be a nightmare to fix up this spring.

 

[DarkShadow]

drill a few holes and get some hand strength pumping in thick ass urethane....id prob rip my dick of if i still bait'd nowadays

Thats something we did not need to know, James....

 

[RICH17]

Sweets!!! Hopefully its worth the extra saving from doing real poly mounts. race junk on the cheap FTW

 

[GTwolf]

IN, I've been through 2 sets of stock mounts in the past 20-30k miles.

 

[RICH17]

bump for the ones who are wondering about these

 

[GTwolf]

I would love a pair, PM me some prices?

 

[RICH17]

for a full trans mount and motor mount hows 150?

 

[Alacran]

Motor mount acquired. Another Anchor that does not make noise. Need more details on the drilling. I dont want to drill on the side unless i have to.

 

[GTwolf]

for a full trans mount and motor mount hows 150?

Sounds good!

 

[RICH17]

itll be about a month before theyre cured tho