04+ GP Keyfob Programming

EmersonHart13

TCG Elite Member
TCG Premium
Jul 18, 2007
54,215
22,341
The following is the procedure used:

************************************************** ************************************************** ***********************

Up to 4 transmitters may be programmed. The order of programming is important. First transmitter to be programmed is #1, and the second as transmitter #2.

Invalidate All

The following will erase all keyless entry transmitters from memory and ensure the DIC presents accurate key fob status since key fob battery status is monitored and displayed on the DIC when low.

1) Install the GM Tech II scan tool at the ALDL port under the steering column.
2) Turn ignition to ON with engine not running.
3) At scan tool select Body.
4) Select Remote Control Door Lock Receiver (RCDLR).
5) Then select Module Setup.
6) Select Program Key Fobs.
7) Select Invalidate All Fobs.
8) Follow scan tool on-screen instructions.

Transmitter Slot Programming

1) Install GM Tech II scan tool to ALDL port.
2) Turn ignition to ON with engine not running.
3) At scan tool, select Body.
4) Select Remote Control Door Lock Receiver (RCDLR).
5) Select Module Setup.
6) Select Program Key Fobs.
7) Select the key fob to be programmed.
8) Follow scan tool on-screen instructions.
9) Remove scan tool from ALDL port.
10) Exit vehicle. Test key fob(s) operation consisting of LOCK, UNLOCK, PANIC (Horn sounds), TRUNK RELEASE and REMOTE START if equipped.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info

  • EmersonHart13
    Created
  • 4
    Replies
  • 311
    Views
  • Participants list