Refurbished GenIII M90
60K. This is a unit I was going to install on my GTP engine rebuild back in 2006.
I cleaned the unit, regreased the needle bearings, installed a new ZZP SC coupler ($30) and a new PCV valve. Installed a new vacuum port on the top. I'm also including the spark plug wiring bracket that attaches to the snout and two (2) bottles of GM SC oil.
Boost Bypass Valve not included. I have one I will sell with the unit for an extra $50 (that's what I paid for it from Ed Morad.) I'll turndown the snout for an extra $20. (Allows you to run pulleys smaller than 2.8".)
This would be great for someone looking to try a home port and polish.
$200 OBO (Local pick-up only. Shipping would be about $25-$30.)
60K. This is a unit I was going to install on my GTP engine rebuild back in 2006.
I cleaned the unit, regreased the needle bearings, installed a new ZZP SC coupler ($30) and a new PCV valve. Installed a new vacuum port on the top. I'm also including the spark plug wiring bracket that attaches to the snout and two (2) bottles of GM SC oil.
Boost Bypass Valve not included. I have one I will sell with the unit for an extra $50 (that's what I paid for it from Ed Morad.) I'll turndown the snout for an extra $20. (Allows you to run pulleys smaller than 2.8".)
This would be great for someone looking to try a home port and polish.
$200 OBO (Local pick-up only. Shipping would be about $25-$30.)
