3800 Ordering new rockers very soon...

  • Thread starter imported_Theautoguy
  • Start date
I

imported_Theautoguy

Guest
I’m finally going to order new rockers but I have a few questions first;

My initial thoughts are to get the 1:9’s but I’ve heard some concerns over piston clearance and valve train stress. (The car never see’s more than 6200 RPM.)

I do have the LS1 springs (yellow ones?!?) and new retainers but I don’t know if I can reuse my old rocker bolts and push rods.

Will I have problems getting the rear valve cover off without removing the water pump housing? I trust that since the higher ratio rockers are refurbished stock pieces that if the cover comes off well enough then the cover should go back on well enough too?

Opinions welcomed…
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info

  • I
    Created
  • 4
    Replies
  • 300
    Views
  • Participants list