Hey guys, in an effort to keep my TB mounted in the stock location on my custom upper intake manifold, i need a measurement. Basically I need to know the horizontal distance between the top TB nut to the first M90 bolt to its right. Looking from the drivers side.
Also, Just need to confirm that the TB runs parallel with the angle on the lower intake. Basically, I know the TB is turned a little towards the front of the car. But I need to know if it follows the angle that the intake manifold makes, right below the TB.
You can see the angle im talking about here. Were it runs from the bolt the the tstat housing, right where the TB would sit.
Thanx guys.
Also, Just need to confirm that the TB runs parallel with the angle on the lower intake. Basically, I know the TB is turned a little towards the front of the car. But I need to know if it follows the angle that the intake manifold makes, right below the TB.
You can see the angle im talking about here. Were it runs from the bolt the the tstat housing, right where the TB would sit.
Thanx guys.
