3800 gmpp strut tower brace?

I

imported_GraFFix

Guest
yes you have to drill holes in the strut tower, then put the bolts thru the holes from the wheel well then put the clips on the top to hold the bolds from falling back down. its easiest with 2 people but is possible to do it alone.

Just make sure you center it as best you can. you can also put the same bar on the rear strut towers but you dont have to drill the tower for those, you just have to open 2 of the holes on the strut brace with a drill to fit over the bolts in the trunk
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info