Torque specs for tie rod end/castle nut

m_dogg

TCG Elite Member
TCG Premium
Oct 23, 2008
5,503
5,577
Getting annoyed with different answers online...I've seen anywhere from 35, 45, 52 ft/lbs for the outer tie rod end nut. Anyone knows what it should be? I torqued it town to 45ft/lbs but then the castle nut is quite a few turns past the cotter pin hole which worries me a little...Original tie rod ends didn't use cotter pins but the nut was much larger.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info