3800 DIY clear corners...

[syP]

Well.. as of now i am trying to break the reflector... but this thing will not break.. i am hitting it very hard too.... JEEZ.

Click to read more...

 

[LPSPEED2]

HEAT IT UP A BIT IF YOU CAN, OTHERWISE USE A DRILL TO MAKE SMALL HOLES (4-6) OF THEM, IT WILL MAKE THE REFLECTOR EASIER TO BREAK.

 

[LPSPEED2]

BTW, IF YOU HEAT IT UP, IT COMES OUT MUCH CLEANER, BUT YOU NEED TO WATCH OUT, AND NOT MELT THE BULB HOUSING.

 

[syP]

yea.. i just had to hit it harder and not be afraid.. once 1 cracks.. the peices are MUCH easier.. If i can do this mod... any1 can. I didnt even crack the clear housing around it. I did scratch it up alot though

#1

#2

#3

#4

#5

Doesnt that gap in pictured 3 and 4 Look extremely big??? whats with that? wow.

Came out well otherwise.

ryan

 

[sweetness]

your headlight on the pass side looks like it is out of alignment. did you have a hard time getting it lined up?? that pass light can be difficult if you don't have the battery relocated.

BC

 

[syP]

i didnt touch the headlight.. i only took out the side light.

 

[zeez gtp]

looks good

when i bought mine, one had a bigger gap, i just had to readjust it a bit and then it filled in nicely, but nice job

zack

 

[mybluegtp]

Looks good.. B)

 

[antpearl]

sweet i did mine too...now i'm not the only one whose are scratched.. j/k looks good and didn't cost a fortune....

 

[smokngtp]

when i did mine i used a srcrew and a screw driver to slowly crack it into pieces. i had a heck of a time trying to do it with just a screwdriver and a hammer. when you use a screw, you don't risk going through the reflector to quick and scratchin up the lens. just wondering, but has anyone whos done this mod left the bulb in? i ended up taking mine out because i tried it with a colored bulb, but it didn't look right. plus i don't like the look of the clear colored turn signals. but its not that obvious , so i don't worry about it.