This needs a 3800. #swapallthethings

Yaj Yak

Gladys
TCG Premium
May 24, 2007
122,872
89,538
Niche score of 2,363
1996 4cylinder stick shift jeep cherokee

1996 4cylinder stick shift jeep cherokee - $1700 (chicag0)

image 1image 2image 3image 4image 5image 6image 7image 8image 9image 10image 11image 12


© craigslist - Map data © OpenStreetMap
(google map) (yahoo map)

1996 jeep cherokee odometer: 131000 manual transmission

selling my 96 jeep Cherokee sport with 131000 miles 5 speed manual transmission
runs very good no mechanical issues small dent in the front fender as you can see on picture
only reason i am selling is cause i just got a 4 door automatic car for more info or to set up a test drive
call me at 312863114seven serious buyers only, sorry no personal checks, clean private title on hand


00303_hGg0deaeMef_600x450.jpg
 

Yaj Yak

Gladys
TCG Premium
May 24, 2007
122,872
89,538
Niche score of 2,363
This seems like it should be here.


Details to put a buick supercharged 3800 into a jeep.

Use a Dakota 4 cylinder bell housing and a jeep 5 speed behind a 3800. :fy:

What trans is it? That thing would be nasty set up right awd turbo 3800, or is it 2wd?

3800 Bible - Page 14 - Pirate4x4.Com : 4x4 and Off-Road Forum

The jeep four cylinder has a GM 60 degree bell housing pattern which it inherits from the old Iron Duke four cylinder. Here is a nice site for gm 60 degree swaps. Engine Swap Bellhousings - Jeeps-Offroad.com Bulletin Board

Now, the 1996-1998 Dodge Dakota came with the 2.5 engine and the ax-15 transmission. As a result, the Dakota bellhousing will allow you to bolt the 3800 to a jeep ax15 or nv3550 transmission. (I have one of these) (It will also allow guys to replace the weak ax5 transmission behind their 4 cylinders with an ax15).

FLYWHEEL/CLUTCH

The L36 flywheel from a RWD Camaro (I have one of these) will bolt to a FWD L36 or L67. Use the pressure plate (I have one of these) from the camaro and you will need a clutch from a 1983-84 four cylinder/four speed. The 9 1/8" outside diameter will fit the camaro flywheel/pressure plate and the 1 1/8" with 10 teeth will fit the jeep transmission input shaft. Here are a couple of sites that really help!!! Pirate4x4.Com : 4x4 and Off-Road Forum - Powered by vBulletin Kiwi's L67 in 94' xcab build - Pirate4x4.Com : 4x4 and Off-Road Forum I was going to use a hydraulic throwout bearing, fork, master, slave, etc. from a 1994 yj.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant. Consider starting a new thread to get fresh replies.

Thread Info