For the IRS folks..

[Racerx66]

...in case you haven't seen this new piece.

http://www.lethalperformance.com/pa...08-control-freaks-rear-support-irs-cover.html

Click to read more...

 

[nytebyte]

Could you use this in place of the Billetflow IRS cover brace?

 

[99 Stangbanger]

Looks like it ties into the IRS subframe :headbang:

 

[Maniak]

looks like a nice peice. i find it funny that they said "improves undercarage apearance" :lmao:

 

[ShelbyGuy]

The billet ones that Dougie made came out to something like $850. $300 for this casting isnt that bad of a price.

The real benefit (aside from being thicker) is the preload studs for the differential bearing caps - wheel hop tears the cover apart, but big power will rip the bearing caps out of the housing.

I'd still rather have a billetflow diff brace than this cover. Castings are porous and while appearing stronger than stock, I would bet that the cover in the link above is still prone to becoming shrapnel. But I type that without having held one in my hot little hands.

Just an opinion, but as always, my opinions are fully guaranteed. If you arent completely satisfied, the next opinion is free.