I've been putting together my 94 Mitsu 3000GT VR-4 and I finally got to swapping out all my rubber bushings to polyurethane. I've noticed while moving my subframe around that it creaks and squeaks a lot.
I did use a very small amount of the bushing grease, but I am afraid I did not use enough.
Mainly I am hoping that when I finally drive the car around that it won't creak and squeak over every bump.
Any thoughts? Do you think it will just have to be worked in and flexed a bit?
I did use a very small amount of the bushing grease, but I am afraid I did not use enough.
Mainly I am hoping that when I finally drive the car around that it won't creak and squeak over every bump.
Any thoughts? Do you think it will just have to be worked in and flexed a bit?